Wear test has been completed on two types of layered materials: a non-reinforced enamel plate and a ceramic reinforced enamel plate. The latter has been tested in two forms: with 10st% and 20wt% ceramic particles reinforcement. For comparison, the same test has also been completed on polished steel. Wear resistance was measured using a tribometer, equipped with a chromium steel sphere of 6mm diameter. The sphere-plate surface contact area increases with distance covered, which in the polished steel provokes exponential increments in wear values. This exponential behaviour was not observed in the enamel plates due to their greater wear resistance. The reinforcement of the enamel plates with ceramic particles increases the wear resistance. A higher percentage of ceramic reinforcement results in a greater wear resistance of the plates.